Expoimaging ExpoDisc Quickstart Guide Bedienungsanleitung PDF herunterladen

C. AMBIENT LIGHT PHOTOGRAPHy

When photographing subjects under ambient light, it is best to stand in similar light as your subject and point the

camera towards the main light source. If there is not a dominant light illuminating your subject, then it is important

to capture the combined incident and reﬂ ected light falling on your subject by pointing the camera back towards

the location from where you will take the picture.

D. FLASH PHOTOGRAPHy

The best results are obtained when light from the ﬂ ash passes through the ExpoDisc in the custom white balance

procedure. This is most easily accomplished when using removable ﬂ ash units, or when utilizing bounce (reﬂ ected)

ﬂ ash to illuminate the subject.

Camera-Mounted Bounce Flash. When using bounce ﬂ ash to illuminate the subject, aim the camera and the ﬂ ash

towards the bounce surface (e.g., ceiling) for your custom white balance capture.

Camera-Mounted Direct Flash. When using camera mounted ﬂ ash units to directly illuminate the subject, remove

the ﬂ ash (if possible) and position it at your intended shooting position (either set it on a ﬂ at surface, or use a

tripod or assistant). Then, from your subject’s intended position, set the custom white balance by aiming the

camera back towards the ﬂ ash unit.

Note. We do not recommend setting a custom white balance while using camera-mounted direct ﬂ ash if you

cannot remove the ﬂ ash unit to set the custom white balance. The ExpoDisc is an incident tool, aiming the

camera at the subject to set a custom white balance may not incorporate enough light from your camera mounted

ﬂ ash, and instead may create a colorcast by incorporating disproportionate amounts of back-lighting or side-lighting.

Flash Positioned Off-Camera. When photographing with remotely positioned, removable ﬂ ash units it is important

to position or place the ﬂ ash at its intended lighting position, then from subject position aim the camera back

towards shooting position for your custom white balance capture.

www.expodisc.com

tips for specific applications - continued

121 Aviation Way, Watsonville, CA 95076

Phone 800.446.5086

(Only within U.S.A)

expodisc

Professional Digital White Balance

Quickstart Guide for diGital cameras

www.expoimaging.net

1 2

Phone 800.446.5086 1

Inhaltsverzeichnis

Seite 1 - Phone 800.446.5086

C. AMBIENT LIGHT PHOTOGRAPHyWhen photographing subjects under ambient light, it is best to stand in similar light as your subject and point the camera

Seite 2

expodiscQuickstart Guide for diGital cameras1. INSTALL THE EXPODISC. Snap the ExpoDisc over the front of your lens (white side towards camera). Sin

Weitere Dokumente für Fotozubehör Expoimaging ExpoDisc Quickstart Guide

Um das Dokument anzuzeigen Expoimaging ExpoDisc Quickstart Guide Bedienungsanleitung

Expoimaging ExpoDisc Quickstart Guide Bedienungsanleitung (2 Seiten)

Kommentare zu diesen Handbüchern

Keine Kommentare

Expoimaging ExpoDisc Quickstart Guide Bedienungsanleitung

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Fotozubehör Expoimaging ExpoDisc Quickstart Guide herunter. ExpoImaging ExpoDisc Quickstart Guide User Manual Benutzerhandbuch

Inhaltsverzeichnis

Weitere Dokumente für Fotozubehör Expoimaging ExpoDisc Quickstart Guide

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Fotozubehör Expoimaging ExpoDisc Quickstart Guide